Bethers wrote:To put it simply - you need a converter from 30 amp to 110. Many campgrounds, when you plug in - have 50, 30 and 110 in the hook-ups - so you can plug in something else there if need be. I always ran the trickle charge to my scooter directly from the cg 110. You really should have this converter anyway - like how I needed it below.
I have plugged into many friends and families houses. And you can run the micro or hair dryer - but ONLY one of them at a time - and I wouldn't try the air conditioner, although it might work. It will all depend on what else they may have on that circuit. If nothing else, you can do more - like here, when my 30 amp went out at this cg, I had the rv plugged overnight into the 110. I did make popcorn, but otherwise, didn't use anything but fridge, lights and tv. If I'd wanted to use my hair dryer, I could have, but wouldn't have used the micro at the same time.
What Lenora says is basically true - but you can use your heater if it's gas with blower - but I don't recommend using an electric heater. You can use the skillet, crock pot, etc - just like you could in a house. Again, just be careful because you're running everything off ONE circuit (you know how your house has many) and otherwise, you could blow your fuses in the rv and you could blow their fuses in their house.
This is sounding complicated, it's not. Plug in - enjoy. However, if it'll be super hot there - you won't have your air conditioner.
mitch5252 wrote:Question (taken from the internet)
If you could help me understand the difference between the 50 amp and 30 amp outlets I would appreciate your advice. Is the 50 amp a 220 line ? with a 20 and 30 amp or is it a 50 amp at 120 ? To add to the confussion is the 4 prong plug 50 amp ? Thank you for your help ! Larry
Answer
One supplies up to 30 amps of voltage, one supplies up to 50 amps of voltage. 30/50 amp outlets are usually always 220 volt. The 220 volt plugs are configured as to not to be confused or interchanged with the standard three prong 110 volt plugs . A 220 plug has two hots, a neutral and a ground whereby a 110 volt plug has just one hot, one neutral and one ground.
Janet, hope this helps.
..
Users browsing this forum: No registered users and 4 guests