loose wire somewhere and now no jacks!
Posted: Wed Mar 15, 2017 6:42 pm
Hi all,
While at the Hillsborough SP GTG I had a problem deploying my jacks. My rig is a 2003 Coach House Platinum. The jacks are HWH, not sure of the model at the moment (too cold and windy to go back outside!). To deploy the jacks I have to engage the emergency brake, then turn the key to accessory, then turn on the jack control panel. The unit powers on but lights up that the parking brake is not engaged. I had seen this once before but went through the steps a couple of times and it straightened itself out. No such luck this time.
Hubby jiggled the wire leading from the brake and both the dash brake light and the brake light on the HWH panel would go on and off. So we are thinking a loose connection. Called Coach House since we were in the area - could not make an appt for service on short notice but the manager showed us where the wiring was - a big bundle of wrapped wires under a panel near the hood release.
Has anyone else had this problem with their HWH jacks? I don't mind taking it for service at a shop, but am still looking for someone I feel good about. I do have a feeling it is an easy fix....if I can only find the connection!
Also, Martha if you read this (or anyone else with a CH) do you have a wiring diagram in your owner's manual by chance?? I have called CH but haven't gotten a call back yet. Will bug them again tomorrow
Thanks for any advice!
While at the Hillsborough SP GTG I had a problem deploying my jacks. My rig is a 2003 Coach House Platinum. The jacks are HWH, not sure of the model at the moment (too cold and windy to go back outside!). To deploy the jacks I have to engage the emergency brake, then turn the key to accessory, then turn on the jack control panel. The unit powers on but lights up that the parking brake is not engaged. I had seen this once before but went through the steps a couple of times and it straightened itself out. No such luck this time.
Hubby jiggled the wire leading from the brake and both the dash brake light and the brake light on the HWH panel would go on and off. So we are thinking a loose connection. Called Coach House since we were in the area - could not make an appt for service on short notice but the manager showed us where the wiring was - a big bundle of wrapped wires under a panel near the hood release.
Has anyone else had this problem with their HWH jacks? I don't mind taking it for service at a shop, but am still looking for someone I feel good about. I do have a feeling it is an easy fix....if I can only find the connection!
Also, Martha if you read this (or anyone else with a CH) do you have a wiring diagram in your owner's manual by chance?? I have called CH but haven't gotten a call back yet. Will bug them again tomorrow
Thanks for any advice!