
So at the moment I have two boards in place, an 2x6 and a 2x4. Ideally, a 2x10 would have been better, but I can’t handle that size of pressure treated board anymore. Too heavy. I have the gravel down for the step base. This is a work in progress area at the moment.

But before I do anymore on that part, I want to even off that edge where the deck boards are sticking out. aDon’t want a tripping hazard there. Being the deck boards look even all the way across the width of the porch, the joist underneath is not straight. So there is anywhere from a half inch to 3/4 inch between the edge of those deck boards and the joist where I attached my boards, between the two posts. . So a bit of experimenting going to happen here.
