Afternoon all. Chilly, rainy and wi day here. Temp 45 degrees. Just got home from Chiropractor, grocery run and Had bowl of Clam Chowder for lunch. Pups want a potty walk, so will oblige in a few minutes. Lull in the rain at the moment.
For those on here with travel trailers, there is an industry wide Propane Regulator recall. I think it also applies to some MH’s as well.
Component Description : Propane Regulator with supply hoses. Model 6020.
: Certain Winntec model 6020 two stage propane regulators installed on the recreational vehicles may supply elevated, intermittent or low propane pressure to the appliances.
Description of the Safety Risk : An increase in propane pressure, could cause the flame of the appliance to become larger, and under certain rare circumstances, may ignite adjacentmaterials resulting in a fire. Appliances that can be effected by an excessive
flame are the stovetop, oven, hot water heater, furnace and refrigerator. Description of the Cause : Certain Winntec model 6020 two stage propane regulators, contain a secondstage valve seat that can fail to regulate propane flow and pressure in two different ways. First, the second stage valve seat in the regulator has an inadequate mechanical lock, resulting in seal migration. Once out of position, the valve seal will not properly regulate propane flow and pressure to the recreational vehicle appliances. Second, the rubber hoses (pigtails) that connect the onboard propane cylinders to the regulator release a plasticizer which is a liquid that collects in the body of the regulator. When in contact with the the plasticizer, the physical properties migrate out of position.
Irregular performance from the recreational vehicle appliances may be an indicator that the propane regulator is experiencing the safety defect. The smell of propane may be present at the regulator, which would indicate the regulator is venting at high pressure.
I think this is probably affecting newer model RV’s like Cheryl’s, rather than older ones.
You will need to make an appt. at a dealer to have it replaced. Units affected by this recall will have the Winntec Model #6020 LP Regulator removed and replaced with either a Fairview Model #GR994 or a YSN Imports Model #ACR2. Once the LP Regulator is replaced, Dealers will be required to perform industry standard LP System validation. Requirements include leak detection, timed pressure drop test and a regulator lockout test. This is at no cost to owners.
Just wanted to alert y’all. This recall is issued by the NHTSA.
So I will leave you with that news today and head out with the pups before more rain moves in. Then will put together my 2nd side table and get the two current ones out on Marketplace. Posted an ad for a 26 inch Brand new Sanyo LCD HGTV yesterday. Bought it to exchange the one in my trailer awhile back and never did. So will sell it instead. Need to transfer a few dollars to checking account to pay MasterCard bill and all that usual stuff. Like Karen, I’m exercising that card too a bit too